Address-Family (Eigrp) - Cisco Nexus 3548 Command Reference Manual

address-family (EIGRP)

address-family (EIGRP)
To configure an address family for the Enhanced Interior Gateway Routing Protocol (EIGRP), use the
address-family command. To remove an address family, use the no form of this command.
Syntax Description
ipv4
unicast
Command Default None
Command Modes
Router configuration mode
Address family configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines This command requires the LAN Base Services license.
Examples This example shows how to set the IPv4 unicast address family for an EIGRP instance:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# address-family ipv4 unicast
switch(config-router)#
Related Commands Command
default-information
default-metric
distance
maximum-paths
redistribute
router-id
show ip eigrp
timers
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
14
address-family ipv4 unicast
no address-family ipv4 unicast
Specifies the IPv4 address family.
Specifies unicast address support.
Modification
This command was introduced.
Description
Controls the distribution of a default route.
Configures the default metric for routes redistributed into EIGRP.
Configures the administrative distance.
Configures the maximum number of equal-cost paths.
Configures route redistribution for EIGRP.
Configures the router ID.
Displays EIGRP information.
Configures the EIGRP timers.
Chapter Unicast Routing Commands
OL-27852-01