Ip Local-Proxy-Arp - Cisco Nexus 3548 Command Reference Manual

ip local-proxy-arp

ip local-proxy-arp
To enable the local proxy Address Resolution Protocol (ARP) feature, use the ip local-proxy-arp
command. To disable this feature, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled
Command Modes Interface configuration mode
Subinterface configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
Before the local proxy ARP feature can be used, you must enable the IP proxy ARP feature by using the
ip proxy-arp command. The IP proxy ARP feature is disabled by default.
This command is not applicable to Layer 3 loopback interfaces.
Note
This command requires the LAN Base Services license.
Examples This example shows how to enable the local proxy ARP:
switch# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip arp local-proxy-arp
switch(config-if)#
Related Commands Command
copy running-config
startup-config
ip proxy-arp
show ip arp
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
172
ip local-proxy-arp
no ip local-proxy-arp
Modification
This command was introduced.
Description
Saves the configuration to the startup configuration file.
Enables proxy ARP on an interface.
Displays ARP configuration information.
Chapter Unicast Routing Commands
OL-27852-01