Address-Family (Rip) - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

address-family (RIP)

To configure an address family for the Routing Information Protocol (RIP), use the address-family
command in router configuration mode.
Syntax Description ipv4
unicast
Command Default This command has no default settings.
Command Modes Router configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines This command does not require a license.
Examples This example shows how to set the IPv4 unicast address family for a RIP instance:
switch# configure terminal
switch(config)# router rip Enterprise
switch(config-router)# address-family ipv4 unicast
switch(config-router)#
Related Commands Command
default-information
default-metric
distance
maximum-paths
redistribute
show ip rip
timers
OL-27852-01
address-family ipv4 unicast
Specifies the IPv4 address family.
Specifies unicast address support.
Modification
This command was introduced.
Description
Controls the distribution of a default route.
Configures the default metric for routes redistributed into RIP.
Configures the administrative distance.
Configures the maximum number of equal-cost paths.
Configures route redistribution for RIP.
Displays a summary of RIP information for all RIP instances.
Configures the RIP timers.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
address-family (RIP)
15