Hardware Ip Glean Throttle Syslog - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

hardware ip glean throttle syslog

To generate a syslog if the number of packets that get dropped for a specific flow exceeds the configured
packet count, use the hardware ip glean throttle syslog command. To return to the default setting, use
the no form of this command.
Syntax Description
pkt-count
Command Default
10000
Command Modes Global configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines Before you use this command, make sure that you enable the IP glean throttle feature by using the
hardware ip glean throttle command.
After the timeout period is exceeded, the drop adjacencies are removed from the FIB.
The Adjmgr generates a syslog for the configured packet count that will not be accurate to the dropped
Note
glean packets that are forwarded to the FIB. The drop statistics collected from the FIB in the software
(Adjmgr) occurs every 2 minutes. The Adjmgr generates a syslog only after it receives the statistics from
the FIB every 2 minutes only for the adjacencies where the drop count exceeds the configured packet
count.
This command does not require a license.
Examples This example shows how to generate a syslog if the number of packets that get dropped for a specific
flow exceed the configured packet count:
switch# configure terminal
switch(config)# hardware ip glean throttle syslog 1030
switch(config)#
OL-27852-01
hardware ip glean throttle syslog pkt-count
no hardware ip glean throttle syslog
Packet count. The range is from 0 to 65535.
packets
Modification
This command was introduced.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
hardware ip glean throttle syslog
135