Show Routing Hash - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Show Commands

show routing hash

To display the load-balacning hash information, use the show routing command.
Syntax Description
ipv4 address
Command Default None
Command Modes Any command mode
Command History Release
5.0(3)A1(1)
Usage Guidelines This command is not supported in Warp mode.
Examples This example shows how to display the load-balacning hash information:
switch(config)# show routing hash 4.1.1.2 130.0.0.1
Load-share parameters used for software forwarding:
load-share mode: address source-destination
Universal-id seed: 0x6fe75e69
No IPv4 protocol specified, defaulting to UDP
Invoking pc_ip_ecmp_resolution
Hash for VRF "default"
Hashing to path *Eth1/4%
For route:
130.0.0.0/8, ubest/mbest: 4/0
Related Commands Command
clear ip route
OL-27852-01
show routing hash [ ipv4 address]
Specifies the IPv4 address.
Modification
This command was introduced.
*via 2.1.1.2, Eth1/2, [1/0], 5d18h, static
*via 3.1.1.2, Eth1/3, [1/0], 5d18h, static
*via 4.1.1.2, Eth1/4, [1/0], 5d18h, static
*via 140.0.0.2, Po2, [1/0], 5d18h, static
Description
Clears entries in the route table.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
show routing hash
511