Log-Adjacency-Changes (Eigrp) - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

log-adjacency-changes (EIGRP)

To enable the logging of changes in the Enhanced Interior Gateway Routing Protocol (EIGRP) adjacency
state, use the log-adjacency-changes command. To disable the logging of changes in the EIGRP
adjacency state, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default
Adjacency changes are not logged.
Command Modes Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines This command requires the LAN Enterprise Services license.
Examples
This example shows how to enable logging of adjacency state changes for EIGRP 1:
switch# configure terminal
switch(config)# router eigrp 1
switch(config-router)# address-family ipv4
switch(config-router-af)# log-adjacency-changes
switch(config-router-af)#
Related Commands Command
ip eigrp
log-neighbor-changes
ip eigrp
log-neighbor-warnings
show ip eigrp interfaces
OL-27852-01
log-adjacency-changes
no log-adjacency-changes
Modification
This command was introduced.
Description
Logs changes to neighbors for an interface.
Logs neighbor warnings for an interface.
Displays information about EIGRP interfaces.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
log-adjacency-changes (EIGRP)
217