Teletek electronics CA62 Installation And Programming Manual page 44

44 Installation and Programming Manual - СА62 Alarm Control Panel
ADDReSS 6021 - eNteRING PRotoCoL 2 NUMBeR FoR tHe CoMMUNICAtoR
Enter central station No. 1 protocol number from the attached table. Valid are the symbols from 1 to
2, where:
Button
PRotoCoL 2
1
2
*
Note: See also the code tables in the APPENDIX C.
Default settings - SIA
ADDReSS 6022 - tYPeS oF MeSSAGe tRANSMItteD FRoM tHe DIGItAL CoMMUNICAtoR, FoR PRot. 2
Messages
The programming is the same as for ADDRESS 6012.
Default settings - No messages are assigned
ADDReSS 6030 - ReCoRDING AND LISteNING oF VoICe MeSSAGeS
You can record and listen to messages in the voice dialer at this address.
VD60 Voice
At APPENDIX Е is given a detailed algorithm for recording and listening to of the voice messages.
Dialer Pro-
Note: Recording and listening of voice messages can be done only if a voice dialer VD60 is integrated
gramming
to the CA62 control panel (main PCB ).
ADDReSS 6031 - eNteRING teLePHoNe NUMBeR 1 FoR tHe DIALeR
A telephone number is assigned for communicating via voice dialer No. 1. The indication is hexadeci-
mal. The telephone number must not exceed 16 characters
Some special functions can be entered by using the next button combinations:
1. Buttons ARM + 0 - Switches on "pulse dialer".
2. Buttons ARM + 1 - Switches on "tone dialer".
3. Buttons ARM + 2 - 2 seconds pause.
telephone
4. Buttons ARM + 3 - Switches on "Wait dial tone".
number 1 for
5. Buttons ARM + 4 - "Blind dialing"; Switches off "Wait dial tone".
the dialer
6. Buttons ARM + 5 - Deletes the entered telephone number*.
Dialing has been assigned a default tone signal and "Wait dial tone" function is switched on.
The entered telephone number and the special functions can be saved with pressing the ENT button.
* Note: When there are no entered phone numbers at this address, use this key combination to disable
the option "listening to the telephone line".
Default settings - there are no configured numbers
ADDReSS 6032 - eNteRING teLePHoNe NUMBeR 2 FoR tHe DIALeR
telephone
A telephone number is assigned for communicating via voice dialer No. 2.
number 2 for
The programming is the same as at the ADDRESS 6031.
the dialer
Default settings - there are no configured numbers
ADDReSS 6033 - eNteRING teLePHoNe NUMBeR 3 FoR tHe DIALeR
telephone
A telephone number is assigned for communicating via voice dialer No. 3.
number 3 for
The programming is the same as at the ADDRESS 6031.
the dialer
Default settings - there are no configured numbers
ADDReSS 6034 - eNteRING teLePHoNe NUMBeR 4 FoR tHe DIALeR
telephone
A telephone number is assigned for communicating via voice dialer No. 4.
number 4 for
The programming is the same as at the ADDRESS 6031.
the dialer
Default settings - there are no configured numbers
Protocol
ADEMCO CONTACT ID*
SIA*
Indication
LeD
     
     
LCD
1 2 3 4 5 (6)
1 2 3 4 (5) 6