Teletek electronics CA62 Installation And Programming Manual page 10

10 Installation and Programming Manual - СА62 Alarm Control Panel
Connecting a fire detector with one balancing resistor
Connecting a fire detector with two balancing resistors
a) Connecting a fire detector with a relay in the base
*
b) Connecting of two fire detectors to a doubling zone.
Figure 7. Connecting a fire detector to CA62 alarm control panel.
The programmable output
must be programmed
as Fire Reset and the active
status must be +12 VDC.
Fire
detector
base
* You can use also
two R=510Ω (one R is
connected to every fire
detector), instead of
one R=1k.