User And Manager Codes Programming - Teletek electronics CA62 Installation And Programming Manual

Alarm control panel

Hide thumbs Also See for CA62:

Installation and programming manual (20 pages)

Table Of Contents

Table of Contents

Installation and Programming Manual - СА62 Alarm Control Panel

ADDReSS 1000 - DeFAULt CoNFIGURAtIoN SettING

Setting of

CA62 Alarm control panel supports 4 default parameter configurations.

default con-

Enter a number from 0 to 3 of a default configuration.

figuration

All the menus in this manual are described for the DEFAULT CONFIGURATION 0.

Default settings - 0

ADDReSS 1001 - PRoGRAMMING tHe CoDe DIGItS

The system allows using 4 and 6 digits codes.

Note: When switching from 4- to 6-digits code, the figures 00 will automatically be added at the

Number of

end. For example the 4-digits code 1234 will become 123400.

the code

IMPORTANT: When changing over from 6- to 4-digits code, only the first four figures in the

digits

4-digits code will remain valid. For example the 6-digits code 123456 will become 1234.

Due to risk of coincidence of codes, changing over from 6- to 4-digits code IS NOT RECOM-

MENDED!

The system Engineer, managers and users are using 4

4 digits

digit access codes.

The system Engineer, managers and users are using 6

6 digits

digit access codes.

Default settings

4 digits

ADDReSS 1010 - USeR CoDe 1 AttRIBUteS

USER CODE 1 attributes are assigned at this address.

The user code can have more than one attribute. Pressing a digital button with the respective number

activates the given attribute. The selected attribute is indicated with active number of the pressed digit.

Pressing the same digit again will inactivate the attribute

Only those numbers, which correspond to the assigned attributes, will remain active at the end of the

procedure. Pressing the ENTER button confirms the programmed attributes.

User Code 1

Disarming the system

1. DISARM

Authorizes this user code to Disarm the site.

Arming mode at which the user can stay in certain areas

2. StAY ARM

Authorizes this user code to arm those zones that have not been assigned a STAY attribute.

Zone Bypassing

3. BYPASS

Authorizes this user code to bypass zones in armed site.

Programming

4. PRoGRAM

Authorizes this user code to program system parameters.

Partition А

5. PARt A

Authorizes this user code to operate with Partition A in the security area (bypass, arm, disarm, etc).

Partition В

6. PARt B

Authorizes this user code to operate with Partition A in the security area (bypass, arm, disarm, etc).

Default settings

DISARM, STAY ARM, BYPASS, PROGRAM, PART А; No code*.

* Note: User codes in the system can be programmed only from the Manager Programming Menu.