Patient-Entered Vital Sign Measurements - Honeywell Genesis Touch User Manual

Patient-Entered Vital Sign Measurements

If a patient will be manually entering vital sign measurements from a device, the
Genesis Touch may be configured to accept patient-entered data from a user-
friendly touchscreen interface.
It is recommended to add and configure patient-entered vital signs remotely from
LifeStream. Before manually adding patient-entered vital sign measurements,
check for a LifeStream configuration from the Status menu.
The configuration of patient-entered vital sign data collection may also be accom-
plished via the monitor, and it is similar to the pairing procedures in the previous
section. The following vital sign measurements may be collected via this method:
Patient-Entered Vital Signs
Pulse Meter
Blood Pressure
Pulse Oximeter
Weight
To configure patient-entered vital sign measurement collection:
1. From the Peripherals menu, select Add (
2. A screen similar to the following appears. Here you may select any of the
Genesis Touch - User Manual
applicable vital signs. Scroll down by swiping up on the touch screen with your
finger as shown below:
Temperature
Blood Glucose
Peak Flow
International Normalized Ratio (INR)
).
41