Pairing An A&D Uc-355Pbt-Ci Scale - Honeywell Genesis Touch User Manual

9. Press and hold the Unit button, until you see the Bluetooth icon (
10. Pairing is complete when the Scale screen appears on the Genesis Touch,
11. The Peripherals screen appears, showing the Bluetooth identification number
Note: If you are unable to pair the scale after 30 seconds, or the transmission error icon is
displayed on the scale screen (
and reinsert all batteries prior to pairing. Always use fresh batteries.
Pairing an A&D UC-355PBT-Ci Scale
To confirm your scale type, look at the letters and numbers under the scale display,
which will read UC-355PBT-Ci. If you see UC-321PBT printed on the front of the
scale, please refer to the instructions following this section.
1. Insert 4 AA batteries and place the scale on the ground. If the ground is car-
2. "Pr" is displayed on the scale. Let the scale sit idle for approximately two
3. When ready, press and hold the power button on the scale.
4. Press the button once more and the scale will beep twice.
5. To add a peripheral device, select the Add button (
6. Select Scale in the menu that appears.
Genesis Touch - User Manual
on the scale display.
showing the model and an identifying number of the paired scale. Select Back
to return to the Peripherals menu.
of the scale that has been paired.
peted, use the included carpet stand. See the manufacturer's user manual for
more information.
minutes, or press the start button on the top of the scale, above the display:
You will hear one beep, and "unit" will be displayed, and
you may release the button when you see "uPr" appear as
shown on the right:
You will see "End" displayed:
), repeat these instructions. Completely remove
) blinking
).
19