Table of Contents
Advertisement
Pairing with a Legacy UA-767PBT Blood Pressure Monitor
If you are pairing an older blood pressure unit, complete the following steps:
1. Insert four AA batteries and attach the blood pressure cuff to the blood pres-
2. From the Peripherals menu, select Add.
3. Select Blood Pressure.
4. Select Device.
5. Select the No Device Paired check box.
6. Select A&D and tap OK.
7. Put the blood pressure cuff on your arm.
8. On the Genesis Touch Blood Pressure screen, select Start Pairing.
9. Press Yes when an alert message appears on the monitor.
10. Now briefly press the Start button on the blood pressure unit. The cuff inflates
11. Watch the messages on the screen. When the devices are paired, messages
12. Press the Back button and the Blood Pressure screen appears with the serial
Pairing with a Welch Allyn Blood Pressure Monitor
1. Insert four AA batteries in the blood pressure unit.
2. On the Genesis Touch, select the Add button from the Peripherals menu (
3. Select Blood Pressure in the menu that appears.
4. In the Blood Pressure menu, select Device. The Device button is highlighted:
5. Select the No Device Paired check box.
28
sure unit. Refer to the manufacturer's documentation for operation instruc-
tions.
and messages appear on the Genesis Touch as your blood pressure reading is
recorded.
A valid blood pressure reading will need to be established on the unit and the
cuff may feel tight on your arm. Follow the manufacturer instructions for taking a
proper measurement.
similar to the following appear on the screen ending with "Pairing Succeeded."
number of the paired blood pressure monitor listed.
Genesis Touch - User Manual
).
Advertisement
Table of Contents
Troubleshooting
