Honeywell Genesis Touch User Manual page 32

11. A screen similar to the following appears:
12. On the Genesis Touch Blood Pressure screen, select Start Pairing and then
13. You will see messages similar to the following:
14. Now, press Start on your A&D Blood Pressure monitor but do not hold the
You do not need to establish a valid blood pressure reading, or connect the
Note:
blood pressure cuff, in order to pair with the monitor.
15. Wait approximately 30 seconds as the blood pressure monitor begins to run.
16. An error screen will appear on the blood pressure monitor. Tap Start on the
17. After about 30 seconds, the Genesis Touch will detect the blood pressure
26
select Yes to continue when the following message appears:
button down longer than one second.
blood pressure monitor to clear the screen, but do NOT hold the button down.
monitor.
If you are asked to confirm pairing with the scale, select Yes.
Genesis Touch - User Manual