Honeywell Genesis Touch User Manual page 31

If you are unsure of the model, check to see that Ci shown below the Blood Pres-
sure Monitor Display, as indicated here:
If "–Ci" is not listed: Follow the pairing directions for the legacy UA767PBT model,
after these instructions.
1. Insert four AA batteries in the blood pressure unit and wait approximately two
2. If you plan on pairing the unit to the Genesis Touch immediately, press the
3. When you are ready to begin, press and hold the Start button until "uPr" is
4. Quickly press and release the Start button while "uPR" is displayed.
5. The Blood Pressure monitor will display "END" and turn off. You may now ready
6. On the Genesis Touch, to add a peripheral device, select the Add button (
7. Select Blood Pressure in the menu that appears.
8. In the Blood Pressure menu, select Device. The Device button is highlighted:
9. Select the No Device Paired check box.
10. Select A&D from the menu that appears, and then select OK:
Genesis Touch - User Manual
minutes or until you do not see "Pr" displayed on the blood pressure unit
screen.
round Start button on the Blood Pressure unit to bypass this timeout sequence
and continue.
displayed on the blood pressure monitor.
the Genesis Touch for pairing. If "err10" or "err11" is displayed, try steps 1-3
again.
).
25