Configuring The Profibus Pg/Pc Interface (Only For D410 Dp) - Siemens SIMOTION D410 Commissioning Manual

Parameter assignment / addressing
4.2 Creating a project and configuring the communication
Figure 4-2
Program the following parameters in the "Properties - Ethernet Interface" dialog box:
1. Click "New".
2. Select the new Ethernet subnet which is now displayed in the "Properties - Ethernet
3. Define your addresses in the "IP address" and "Subnet mask" fields of the "Properties -
4.2.3

Configuring the PROFIBUS PG/PC interface (only for D410 DP)

Prerequisites
The following requirements must be satisfied in order to configure the PG/PC interface:
● You have completed the "Insert SIMOTION device" dialog box with "OK".
● A PG/PC has not yet been configured in the project.
If these prerequisites have been satisfied, you can configure the interface for the PG/PC
connection in the "Interface selection ‑ D410" dialog box.
56
Properties of the Ethernet interface
The "New Subnet Industrial Ethernet" dialog box opens. Rename the new subnet, or accept
the default name by clicking "OK".
Interface" dialog box.
Ethernet Interface" dialog box. Change to the "Network node" field and define whether you
are going to use a router and, if yes, enter the router address. Confirm with "OK".
SIMOTION D410
Commissioning Manual, 04/2014