Siemens SIMOTION D410 Commissioning Manual page 78

Commissioning (software)
5.1 Overview of commissioning
SINAMICS S110/S120 Control Unit, and selected Terminal Modules can be interconnected
symbolically.
Table 5-1
Module
SIMOTION D
● SIMOTION D410-2
● SIMOTION D410
● SIMOTION D4x5‑2
● SIMOTION D4x5
Controller extension
● CX32-2
● CX32
SINAMICS S110 CU305
SINAMICS S120
● CU310-2
● CU310
● CU320‑2
● CU320
See also
Only the drive configuration by means of symbolic assignment is described in this
documentation.
The documentation of older SIMOTION versions can be found on the Internet at the following
Internet address (http://support.automation.siemens.com/WW/view/en/40211807) .
For further information on the configuration of the TO axis and TO externalEncoder, see the
TO Axis Electrical/Hydraulic, External Encoder Function Manual.
78
Control units that support a symbolic assignment
Supports symbolic assignment
● As of SIMOTION V4.3
● As of SIMOTION V4.2
● As of SIMOTION V4.2
● As of SIMOTION V4.2
As of SIMOTION V4.2
As of SINAMICS V4.3
● As of SINAMICS V4.4
● As of SINAMICS V2.6.2
● As of SINAMICS V4.3
● As of SINAMICS V2.6.2
Commissioning Manual, 04/2014
SIMOTION D410