Siemens SIMOTION D410 Commissioning Manual page 54

Parameter assignment / addressing
4.2 Creating a project and configuring the communication
3. In the project navigator, double-click "Insert SIMOTION device". The "Insert SIMOTION
4. In the "Insert SIMOTION device" dialog box, select the device, its version and the
5. If required, make further settings:
6. The "Open HW Config" option allows you to select whether HW Config is opened in the
7. Confirm the "Insert SIMOTION device" dialog box with "OK"
PROFINET version
With SCOUT V4.2, for
● SIMOTION V4.0 devices, PROFINET version V2.1 is created
● SIMOTION V4.1 and V4.2 devices, PROFINET version V2.2 is created
54
device" dialog box is opened:
Figure 4-1 Inserting a SIMOTION device
SIMOTION version.
– SINAMICS: for SIMOTION D410 always set SINAMICS S120 Integrated
– SINAMICS version: Select the SINAMICS Integrated version if several drive versions
are available for a SIMOTION version
next step (e.g. to configure the bus interfaces)
SIMOTION D410
Commissioning Manual, 04/2014