Configuring The Properties Of The Profinet Interface - Siemens SIMOTION D410 Commissioning Manual

There is no selection option in the "Insert SIMOTION device" dialog box - in special
circumstances (e.g. for existing systems) PROFINET version V2.1 can also be configured for
V4.1 CPUs. A CPU must be replaced in HW Config for this purpose.
Please note that separate SIMOTION D firmware is available for PROFINET versions V2.1
and V2.2. The required firmware can be found on the SCOUT DVD, as well as at Internet
address (http://support.automation.siemens.com/WW/view/en/31045047).
Mixed operation of the PROFINET V2.1 and V2.2 synchronization processes is not possible
in a network.
Additional references
For further information on IRT in accordance with PROFINET standard IEC 61158 V2.1 and
V2.2, refer to the
Result
If you have not yet configured a PG/PC in your project, you can select the interface for the PG/
PC connection now.
4.2.2

Configuring the properties of the PROFINET interface

Procedure
After you have closed the "Insert SIMOTION device" dialog box by pressing "OK", the
"Properties - Ethernet interface" dialog box is opened on a D410 PN.
If you are using the PROFINET interface, set the interface properties in the "Properties -
Ethernet interface" dialog box.
SIMOTION D410
Commissioning Manual, 04/2014
4.2 Creating a project and configuring the communication
SIMOTION Communication System Manual.
Parameter assignment / addressing
55