Update Via Simotion It Web Server - Siemens SIMOTION D410 Commissioning Manual

Requirement (firmware update)
You can find the latest firmware for SIMOTION D:
● On the SIMOTION SCOUT DVDs (e.g. at ...\3_D4xx\Firmware\V4.2\....).
● at Internet address (http://support.automation.siemens.com/WW/view/en/31045047)
Upgrading the SIMOTION D410 automatically upgrades the firmware of all connected
SINAMICS DRIVE-CLiQ components.
Note
Observe the information in the the Read Me files and the upgrade instructions included in the
scope of delivery of new SIMOTION versions.
Use only CF cards that have been approved for use with the SIMOTION D410 and whose
bootloader version is correct.
You can find the compatibility relationships in the SIMOTION SCOUT Add‑Ons "software
products" compatibility list, as well as at Internet address
support.automation.siemens.com/WW/view/en/18857317).
NOTICE
The upgrade operation deletes all project data and parameters from the CF card!
Back up the data before starting an upgrade.
Requirement (project update)
You have updated your project and, if necessary, adapted the device type and device version.
See Section Adapting a project (Upgrading the project / Replacing the SIMOTION controller)
(Page 174).
6.4.3

Update via SIMOTION IT web server

SIMOTION D410 has a Web server.
In addition to customized web sites and comprehensive device/diagnostic information, the web
server also allows you to update the firmware and project using a standard PC with a web
browser.
As of firmware version V4.2, it is no longer necessary to purchase licenses for the web server
(IT DIAG license) and for SIMOTION OPC‑XML.
Note
An Ethernet or PROFINET interface is required for the web server. For this reason, the web
server is only available on the SIMOTION D410 PN, not the D410 DP.
SIMOTION D410
Commissioning Manual, 04/2014
Maintenance and service
6.4 Performing a firmware and project update
(http://
187