Preparing For A Device Replacement - Siemens SIMOTION D410 Commissioning Manual

Procedure
Proceed as follows:
1. In the project navigator of SIMOTION SCOUT, right-click the SIMOTION controller that is
2. Specify the desired path and start the XML export.
3. When the export has been performed error-free, delete the device from the project and
4. Insert the desired platform as new device in the project navigator of SIMOTION SCOUT.
5. Import the data of the original platform into the new device. To do this, right-click the new
6. Select the location where the XML export data is to be stored and start the import. Confirm
Confirm the message with regard to the import of a "non-compatible type" with "OK".
6.3.6

Preparing for a device replacement

Overview
The device replacement process differs from the platform replacement process in that it is
really easy to accept project data during device replacement.
Device replacement is performed via HW Config, whereas an XML export/import is required
for platform replacement.
A device replacement is only possible within SIMOTION D.
The following devices can be interchanged:
● Replacement between variants (D410 DP ⇔ D410 PN)
● Replacement between different power classes (e. g. D425 ⇔ D435)
● Replacement between generations (D4x5 ⇒ D4x5‑2)
● Replacement of SIMOTION, SINAMICS and/or PROFINET version (e.g.
A SIMOTION D can only be replaced with another if the SINAMICS version involved is the
same or higher. It is not possible to downgrade to a lower SINAMICS version.
SIMOTION D410
Commissioning Manual, 04/2014
6.3 Adapting a project (Upgrading the project / Replacing the SIMOTION controller)
to be replaced.
Select "Expert" > "Save project and export object" in the context menu.
"Save project and export object" exports selected data of the selected object in XML format.
This data export can then be reimported into other projects. The entire project is not
exported, only the data of the selected object (e.g. only the D4x5 or only the SINAMICS
Integrated)
confirm the prompt.
With the selection of the device, you also define the SIMOTION version, and with a
SIMOTION D, also the SINAMICS version.
device and select "Expert" > "Import object" in the context menu.
the prompt to continue with the import.
D410 V4.1 - PN V2.1 SINAMICS S120 V2.5 ⇒ D410 V4.2 - PN V2.2 SINAMICS S120
V2.6.2).
Maintenance and service
179