Configuring An Ethernet Subnet On The Profinet Interface (C240 Pn) - Siemens SIMOTION Operating Instructions Manual

Connecting
6.2 Networking
6.2.5

Configuring an Ethernet subnet on the PROFINET interface (C240 PN)

Overview
You can connect a PROFINET node to the 8-pin RJ45 X11 P1, X11 P2 and X11 P3 sockets,
see Figure "Overview of the cable connecting the C240 PN to the servo drive (digital
connection) - example" in chapter Overview of wiring diagram (Page 92).
PROFINET is a communication network with a transmission rate of 100 Mbit/s.
You can use a PG/PC to communicate with STEP 7, SIMOTION SCOUT, and SIMATIC NET
OPC.
A shielded twisted pair cable is used for the networking in this case. For additional information,
refer to the
document is supplied with SIMOTION SCOUT in electronic form.
All ports of the PROFINET interface support auto-MDI(X) in contrast to the Ethernet interface.
A crossover cable is therefore not required for a direct connection to the PG/PC.
The following connecting cables are recommended:
● SIMATIC NET, Ind. Ethernet FC TP standard cable GP
Article No.: 6XV1840-2AH10 (sold by the meter)
● SIMATIC NET, Ind. Ethernet FC TP trailing cable GP
Article No.: 6XV1870-2D (sold by the meter)
● SIMATIC NET, Ind. Ethernet TP XP CORD RJ45/RJ45, TP cable assembled with two RJ45
plugs, send and receive cables crossed
Article No.: 6XV1870-3R☐☐☐ (☐☐☐ - length code)
● SIMATIC NET, Ind. Ethernet TP CORD RJ45/RJ45, TP cable assembled with two RJ45
plugs
Article No.: 6XV1870-3Q☐☐☐ (☐☐☐ - length code)
The following bus connectors can be used with the C240 PN:
● SIMATIC NET, Ind. Ethernet FC RJ45 plug 145
Article No.: 6GK1901-1BB30-0AA0 (1 item)
Article No.: 6GK1901-1BB30-0AB0 (10 items)
You can obtain additional information about the different cable systems for PROFINET and
Ethernet from your SIEMENS contact.
Loading the PROFINET configuration via PROFIBUS DP (loading of the IP address)
For configuration using PROFINET, the SIMOTION C must be provided with an IP address,
the subnet mask and the router address.
To configure and transfer PROFINET addresses to the C240 PN, proceed as follows:
1. Open your project.
2. Open HW Config. Double-click the X11 "PNxIO" slot of the C240 PN module to open the
"Properties - PNxIO" dialog box.
3. Click the "Properties" button of the Ethernet interface. The "Properties - PNxIO Ethernet
Interface" dialog box is displayed.
126
SIMATIC NET, Industrial Twisted Pair and Fiber Optic Networks Manual. This
Operating Instructions, 11/2016, A5E33441428B
SIMOTION C