Wipe Memory; Normal - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
2
5
or
2 8
7

5.10.2 Wipe Memory

CAUTION: USE THIS OPTION WITH CARE! ALL
CONFIGURATION PARAMETERS WILL BE
To wipe the panel's memory, display the System menu
and proceed as follows:
1 Using the numeric keypad, press the '
select the Wipe Memory option.
[S1 SYSTEM] 1 : Crystal
2 Press the ' ' button to confirm the wipe memory
5
procedure. The LCD displays the following message.
Wipe ALL configuration memory
Press to confirm
Wiping configuration memory
Please wait . . .
When the configuration has been wiped the LCD re-
displays the System menu.

5.11 Normal

The Normal function returns the display to the Level 2
Configuration menu in a normal supervisory mode.
To return to the Level 2 Configuration menu and retain
Level 3 access (Engineer):
1 Press the ' /
2
options (6 : System, 7 : Normal and
the Commissioning menu.
[S1 COMM] 1 : Setup
3 : CBE Rules 4 : Zones 5 : Access
2 Using the numeric keypad, press '
reset and return to normal supervisory mode at the
User Menu.
[S1 COMM] 6 : System
When ALL configuration procedures have been
completed, remember to fit the Configuration
Lock jumper Link (J9).
[S1] 1:Test 2:Disable/Enable
4:View Mode
95
DELETED!
' button to
2
2 : Wipe Memory
< : Cancel
' buttons to display additional
8
: More) from
2 : Circuit
: More
'. The panel will
7
7 : Normal
: More
3:Clock
5:Commission
997-263-000-11, Issue 11
January 2010