Product Inspection; Checking Your Panel For Damage - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
To avoid damage to the
control panel ensure that
you follow these
instructions.
1
2

2.4 Product Inspection

The ID50 Series Fire Control Panels are relatively simple
to install providing the recommended procedures
described in this Installation Guide are followed.
Follow all installation instructions described in this
manual. These instructions must be understood and
the manufacturer's recommendations followed to
avoid damage to the control panel and associated
equipment.

2.4.1 Checking Your Panel for Damage

It is important to check all supplied equipment for
damage before proceeding with the installation!
Before attempting to install your ID50 Series Panel, you
should do the following:
1 After removing the panel, from its packing, and before
you proceed with installing it in its chosen location,
check for any damage that may have been caused
during transit.
Note: In the unlikely event that the panel supplied has
been damaged, you MUST NOT install it but return
it to your supplier. The procedure for returning faulty
items is described in Section 2.4.2, What to do if
Your Panel is Damaged or Suspect.
2 If you are satisfied that the panel has NOT been
damaged you can now proceed with the installation
procedure. This manual addresses the recommended
installation methods of the panel. Refer to the relevant
sections that apply to your configuration requirements.
To prevent unnecessary damage to the electronic
components, the back box should be installed without
the electronics fitted. Refer to Sections 2.5.1 to 2.5.3
for details.
9 997-263-000-11, Issue 11
January 2010