Ancillary Functions - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
CAUTION:
This product is not compliant
EN EN
12094-1 12094-1
with EN 12094-1.
! !
Fire extinguishing installations in
Europe are required to be certified as
compliant to this standard.
997-263-000-11, Issue 11
January 2010
The following features are provided by the Power Supply
Unit (PSU) of the ID50 Series Panel to comply with EN 54-4.
Features of the ID50
Power Supply Unit (PSU)
Derive power supply from main power source
Derive power supply from and monitor a
standby battery source
Charge and monitor the standby
battery source
Detect and signal PSU faults

1.6 Ancillary Functions

The following is a list of ancillary functions that are
provided by the ID50 Series panel in addition to the those
required by EN54-2/4. These functions are described in
the section of this manual as referenced (except those
marked thus ' * ' which are described in 997-264-000-X,
ID50 Series Panel - Operating Manual):
Ancillary
Functions
Site Specific Setup Options
Access Options
Voltage Indications
Control-by-Event
Output modes
Input type pattern
Disable/enablement
Repeater interface
Self-learn configuration - manual
Self-learn configuration - auto
Module supervision options
Module silence options
Text editing
Sensor LED blinking on/off
Bell pulsing ratio
Display of alarm count
Extend delay timer
Sounder Volt-free contact options
Relay drive output option
Extinguishing system features
4
EN54-4
Clause
5.1
5.2
5.3
5.4
Manual
Section Refs.
5.5
5.9
*4.12
5.7
5.7.1
5.7.9
*4.9
2.7
5.6.1
5.6.2
5.6.1
5.7.4
5.8
5.5.3.4
5.5.3.5
*4.11.6
5.5.5.3
4.4.5
4.4.6
5.5.3.7, 5.5.3.8, 5.5.3.9,
5.7.1, 5.7.2, 5.7.10