Device Inputs - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
1
0
or
2
or
1 2
997-263-000-11, Issue 11
January 2010

5.7.9 Device Inputs

The Device Inputs option is only available if the Device
Inputs CBE Rule is selected. This option determines the
output response to up to three (3) specified input devices
(modules or sensors). An input from any of the specified
devices will turn on the associated outputs.
To select the input devices:
1 Follow the procedures in Section 5.7.1, CBE Rules:
CBE nn [INPUTS ]
1 : Change
2 Using the numeric keypad press the '
CBE Rule: nn
3 At the numeric keypad press the '
CBE Rule nn
1:Sensor
8
4 Use the '
CBE Rule nn
1:Sensor
or
3
5 Select either '
CBE Rule nn
Enter sensor address
6 At the numeric keypad, enter the device address and
CBE Rule nn
1:Sensor
Output Type to change the CBE Rule type to Inputs.
The LCD displays the following menu:
[EvSl ]
display the following menu:
1:Type 2:Evac
6:Class Change
the 'Devices' option. The LCD then prompts for a
device type selection (sensor or module) or the
removal of a device that has already been entered.
Alternatively press the '
Device 1: ---
2:Module 3:Remove
/ ' buttons to select one of the 3 Device
2 8
Inputs to be edited.
Device n: Snn
2:Module 3:Remove
' (sensor) or '
1
device address entry, or '
selected device. If a device is to be entered, the
following (example is for a sensor) is displayed:
Device n: ---
press the ' ' button to confirm. Alternatively press
5
' ' repeatedly to cancel the address entry.
4
Device n: Snn
2:Module 3:Remove
90
Dv1 Dv2 Dv3
--- --- ---
' button to
1
4:Silence
10:Devices
' button to select
0
' button to exit this menu.
4
<: Exit
<: Exit
' (module) to select
2
' to remove the currently
3
<: Cancel
<: Exit