Commissioning Tests; Test Leds; Test Lcd; Test Zones - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
6 5
3 Using the numeric keypad, press '
Commissioning option and confirm using the '
pushbutton. The Commissioning option is
automatically displayed if a Level 3 passcode was
previously entered.
[S1 COMM] 1:Setup
3:CBE Rules 4:Zones
If a Level 2 passcode was entered the LCD prompts:
COMMISSION MODE ACCESS
Enter Level 3 Passcode:
4 Enter the correct Level 3 passcode using the numeric
keypad and confirm using the '
press ' ' to cancel the last operation).
4
[S1 COMM] 1:Setup
3:CBE Rules 4:Zones

4.7 Commissioning Tests

The following paragraphs list tests that should be performed
after configuration has been completed. A successful result
from these tests indicates that the panel is working properly.

4.7.1 Test LEDs

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.1.

4.7.2 Test LCD

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.2.

4.7.3 Test Zones

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.3.

4.7.4 Test Auto High Test

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.4.

4.7.5 Test Outputs

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.5.

4.7.6 Test Buzzer

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.6.

4.7.7 Test Keyboard

This procedure is described in the ID50 Series Panel -
Operating Manual, 997-264-000-X, Section 4.8.7.
35
' to select the
6
2:Circuit
5:Access : More
. . . . < : BackSp
' pushbutton (or
5
2:Circuit
5:Access : More
997-263-000-11, Issue 11
January 2010
'
5