Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual page 112

ID50 Series Panel - Installation, Commissioning & Configuration Manual
[Sensor nn - AVS]
1 : Alarm(L5,5) 2 : Day(L5,5)
997-263-000-11, Issue 11
January 2010
AVS Group
The AVSGroup option is used to associate a number of
either AVS or AVR sensors in up to a maximum of 50
groups, see Section 'Co-operative Multi-Sensing'. The
operation of VIEW
follows:
a. VIEW
b. In a group containing both types, the AVS's desensitise
c. In a group containing AVS type sensors, all sensors
Note: One or more AVR's may be configured in a group.
To assign a sensor to a group:
1 From the VIEW
Sensitivity
3 : AVSGroup(01)
2 The LCD prompts for a new AVS Group number. Use
3
[Sensor nn - AVS]
Enter new AVS Group : ____
3 The LCD then returns to the previous display.
[Sensor nn - AVS]
1 : Alarm(L5,5)
A2.4 Automatically Learning VIEW
When automatically learning an SLC Loop including
VIEW
type. The LCD shows the total number of these sensors,
as in the example below:
[Learn]
Any sensors that need to be configured to an AVR type
must be changed individually, see Section A2.2,
Learning Individual VIEW
A2 - 6
TM sensors assigned to a group is as
sensors operate independently if the sensor
TM
is assigned to group 0.
if AVR's detect a sudden rise in contaminated air.
operate as standard VIEW
sensor Sensitivity menu, using the
TM
numeric keypad press '
3
option.
the numeric keypad to enter the required group
number and press ' ' to confirm.
5
Sensitivity
< : Cancel
Sensitivity
2 : Day(L5,5) 3 : AVSGroup(01)
sensors, each sensor is configured as an AVS
TM
TOTAL ION OPT TMP MLT AVS
68 10 20
TM
sensors.
TM
' to access the AVSGroup
Sensors
TM
25 05 08
Sensors.