Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual page 108

ID50 Series Panel - Installation, Commissioning & Configuration Manual
CAUTION!
Use care when including
sensors to AWACS groups as
this may conflict with other
configured operations, such
as coincidence.
3
or
1
2
997-263-000-11, Issue 11
January 2010
Non-VIEW Sensor Sensitivity
TM
The ID60 panel supports co-operative multi-sensing for
sensor types other than VIEW
OPT, MLT, OPX/SM2, SM3 or SM4 sensors a third menu
option, Group, is displayed with the default group number
displayed in the brackets. A sensor may be assigned to
one of up to 50 groups and mixed with other sensor types.
Allocation to a non-zero group enables a sensor's
inclusion in the AWACS
of a sensor to Group 0 excludes it from the AWACS
algorithm and the existing alarm detection algorithm is
used instead (the sensor will operate as a stand-alone
device).
Note: When transferring a configuration from an earlier
version panel, the group number is defaulted to
'1'. This must be changed to '0' for all devices not
being monitored by the AWACS
VIEW devices learnt using software version 5.00,
TM
or above, will default the group to '0'.
Alarm and pre-alarm sensitivity levels can be set in
addition to selecting a multi-sensing group.
1 To change the group, press the '
numeric keypad.
[Sensor nn - AAA]
1 : Alarm (L5,5) 2 : Day (L5,5)
2 Enter a new group number, e.g. 2, and press '
confirm.
[Sensor nn - AAA]
Enter new AWACS Group : ____
3 Using the numeric keypad, to change the alarm and/
or pre-alarm sensitivity levels press the
or to change the Day Mode sensitivity setting, press
the pushbutton.
2
[Sensor nn - AAA]
1 : Alarm (L5,5) 2 : Day (L5,5)
4 At the appropriate prompt enter the desired sensitivity
setting.
A2 - 2
. When configuring ION,
TM
algorithm. However, allocation
TM
TM algorithm. Non-
' button on the
3
Sensitivity
3 : Group (0)
Sensitivity
< : Cancel
pushbutton
1
Sensitivity
3 : Group (2)
TM
' to
5