Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual page 59

ID50 Series Panel - Installation, Commissioning & Configuration Manual
4
6
1
or
2 8
6
To change the RS485 Protocol:
1 From the Setup menu screen, press the '
on the numeric keypad to enter the Peripheral Options
screen. The RS485 Protocol screen is displayed:
[Setup] RS485 Protocol =
> : Change
2 Press the ' ' button repeatedly to step through the
6
alternative protocol settings.
[Setup] RS485 Protocol =
> : Change
[Setup] RS485 Protocol =
> : Change
3 Press ' ' to return to the Peripherals menu screen.
4
5.5.4.4 Third Party Datalink Monitoring
This function is only selectable if Third Party was selected
at the RS485 Protocol screen. Monitoring of the third party
datalink can be enabled or disabled as follows:
1 From the Peripheral Options screen, press the '
button on the numeric keypad to select the RS485
Communications port option. The RS485 Protocol
setup screen is displayed:
[Setup] RS485 Protocol =
> : Change
2 Press the ' /
2
Peripheral Options until the Data Link Monitoring
screen is displayed.
[Setup] Data Link Monitoring =
> : Change
3 If required, press the '
[Setup] Data Link Monitoring =
> : Change
4 Press ' ' to return to the Peripheral Options menu
4
screen.
55
4
NOTIFIER
: More < : Exit
THIRD PARTY
: More < : Exit
BFT/LLT
: More < : Exit
THIRD PARTY
: More < : Exit
' buttons to scroll through the
8
ENABLED
: More < : Exit
' button to select DISABLED.
6
DISABLED
: More < : Exit
997-263-000-11, Issue 11
January 2010
' button
'
1