Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual page 79

ID50 Series Panel - Installation, Commissioning & Configuration Manual
5
6
6
or
2
8
Text Editing is always
Option 4 when device
description text can be
edited.
4
CBE Rule range on line 1 changes, now starting at
'6'. The CBE Rule number in the square brackets on
line 2 also reflects the changed selection:
[Mnn] CBE Rules 06 -------------------------------------------- 29
1: Base [06 +: No ] NNNNNNNNNNNNNNNNNNNNNNNN
4 Press the button to move the cursor to the right -
6
the selected rule number is inverted and is changed
in the square brackets on line 2.
[Mnn] CBE Rules 06 -------------------------------------------- 29
1: Base [13: No] NNNNNNNNNNNNNNNNNNNNNNNN
5 At the selected CBE Rule number, press the
buttons to toggle its status between Y(es) and N(o) -
the change of status is confirmed in the square
brackets on line 2 as follows:
[Mnn] CBE Rules 06 -------------------------------------------- 29
1: Base [13: Yes] NNNNNNNYNNNNNNNNNNNNNNNN
Continue with other CBE Rules in the same way.
Note: After changing the base rule number, the CBE
Rules attributes screen displays the first
associated rule and NOT the selected base rule
number. In the case illustrated above, the number
displayed is '13' and not the base rule number
'6'. If no rule has been assigned, no CBE rule
number is displayed.
6 Press ' ' to confirm or '
5
Rule selection.
Other module types are selected and CBE Rules
associated in the same way as illustrated above. Return
to the 'Modules' selection screen as described in
Section 5.6.1 Signalling Line Circuit (SLC) - Devices.
Refer to the configuration menu option for information
on how to define the pattern (CBE Rule). The pattern
defines whether the output will respond to zonal
alarms. It also determines whether the output is
silenceable and whether any delay is interruptable.
5.6.1.6 Device Text Setting
The Device Text Setting option allows the device
description to be changed. To select the Device Text
option from the displayed menu:
1 Using the numeric keypad, press the '
select the current associated device text. The following
is displayed:
[Sensor nn - AAA] 1 : Zone (nn)
3 : Sensitivity 4 : [
2 The upper line of the display shows the 20-characters
of text currently assigned to the device. The character
that can be changed flashes.
75
' to cancel the new CBE
4
' button to
4
Blank/Existing Text
997-263-000-11, Issue 11
January 2010
/
2 8
]