Circuit Options; Signalling Line Circuit (Slc) - Devices - Honeywell Notifier ID50 Installation, Commissioning & Configuration Manual

ID50 Series Panel - Installation, Commissioning & Configuration Manual
2
1
1

5.6 Circuit Options

The Circuit options menu offers the facility to individually
auto-configure, manually learn or view the following circuits:
a. Signalling Line Circuit - SLC (loop)
b. On-Board Output Circuits - including sounder, control
and relay circuits.
To select the Circuit options menu:
1 From the Commissioning menu, press the '
on the numeric keypad to access the Circuit option menu.
[S1 COMM] 1 : Setup
3 : CBE Rules 4 : Zones 5 : Access
2 The LCD displays the Circuit options available.
[S1 Circuit] 1 : SLC Loop 2 : On-Board
3 Select the number corresponding to the type of circuit
that requires changing, i.e. '
' ' for On-Board.
2
The LCD then displays the appropriate Circuit menu
display.

5.6.1 Signalling Line Circuit (SLC) - Devices

This option enables the manual configuration of devices
to a pre-configured analogue addressable SLC loop.
To manually learn devices on the SLC loop:
1 From the Circuit menu screen, below, using the numeric
keypad press '
1
[S1 Circuit] 1 : SLC Loop 2 : On-Board
2 The LCD displays the Devices and the Learn options. Using
the numeric keypad, press '
[S1 SLC] 1 : Devices
3 Select a device option by using the numeric keypad and
pressing ' ' to configure sensors or '
1
modules (see Input Modules and Output Modules overleaf).
[S1 Device] 1 : Sensors
4 At the prompt, using the numeric keypad enter an address
number and confirm using the '
required device address has been entered, the LCD shows
the current settings and the available editing functions.
[Sensor] Enter Address____
67
2 : Circuit
: More
' for the SLC Loop, or
1
' to select the SLC loop configuration.
' to select the Devices menu.
1
2 : Learn
' to configure
2
2 : Modules
' button. When the
5
997-263-000-11, Issue 11
January 2010
' button
2