Suzuki Wagon R Manual page 2360

Gear Shift Control Lever and Cable Removal
and Installation
Removal
1) Remove console box.
2) Disconnect gear shift and select control cables (1) from gear
shift control lever assembly (2).
a) Disconnect cable end from pivot (7) while pushing cable
end bush (4).
b) Detach cable from bracket (5) while pulling pin (6).
3) Remove gear shift control lever assembly mounting nuts (3)
and gear shift lever assembly (2) from body.
4) Disconnect shift and select cables (1) from transmission in
the same manner as step 2).
5) Remove cable grommet and cable clamp, and then remove
shift and select cables (1) from body.
Installation
Reverse removal procedure for installation noting the following.
• Tighten gear shift control lever assembly mounting nuts (3)
to specified torque.
Tightening torque
Gear shift control lever assembly mounting nut
(a): 13 N·m (1.3 kg-m, 9.5 lb-ft)
MANUAL TRANSAXLE (M13 ENGINE) 7A2-9