Assembling The Pins For The Rear Support Stand M; Positioning The Vehicle On; The Rear Support Stand M - APRILIA RSV mille Workshop Manual

RSV mille
 0/3)4)/.).' 4(% 6%()#,% /. 4(%
3500/24 34!.$
1.8.1 ASSEMBLING THE PINS FOR THE REAR
SUPPORT STAND m
NOTE Have the appropriate special tool m to hand:
– aprilia part# xxxxxxx N.A. [centre stand].
N
Position the vehicle on the side stand on firm and level
ground.
~Position the pin (1) on the appropriate seat on the
rear fork.
~Screw and tighten the screw (2) in the appropriate
threaded hole in the rear fork.
1.8.2 POSITIONING THE VEHICLE ON THE REAR
SUPPORT STAND m
NOTE Have the appropriate special tool m to hand:
– aprilia part# xxxxxxx N.A. [centre stand].
N
Fit the relevant pins, see 1.8.1 (ASSEMBLING THE
PINS FOR THE REAR SUPPORT STAND m).
NOTE
Have someone help you keep the vehicle in ver-
tical position with the two wheels on the ground.
~Loosen the knob (3).
~Move the fork support (4), positioning it so that the
width corresponds to the distance between the two pins
(1) on the rear fork.
~Tighten the knob (3).
N
At the same time introduce the two fork-shaped seats
(4) of the stand (5) under the two pins (1) provided on
the vehicle.
a
CAUTION
Grasping the stand in another way than indicated in
the figure may cause your fingers to be crushed be-
tween the stand and the ground.
N
Grasp the terminal central part of the stand (5) with
your hands (Pos.A).
N
Push the stand (5) downwards until it reaches the end
of its stroke.
1.8.3 POSITIONING THE VEHICLE ON THE FRONT
SUPPORT STAND m
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8146486 (front support stand).
N
Position the vehicle on the appropriate rear support
stand, see 1.8.2 (POSITIONING THE VEHICLE ON

THE REAR SUPPORT STAND m).

N
Insert the two ends of the stand (6) in the two holes (7)
positioned on the lower ends of the front fork.
a
CAUTION
Grasping the stand in another way than indicated in
the figure may cause your fingers to be crushed be-
tween the stand and the ground.
N
Grasp the terminal central part of the stand (6) with
your hands (Pos.A).
N
Push the stand (6) downwards until it reaches the end
of its stroke.
Release 00/2002-10
GENERAL INFORMATION
1 - 21
- 00