Inspecting The Driving Chain Guide Plate; Inspecting The Driving Chain Shoe - APRILIA RSV mille Workshop Manual

SERVICE AND SETTING UP
2.36.5 INSPECTING THE DRIVING CHAIN GUIDE
PLATE
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
N
Remove the lower fairing, see 7.1.34 (REMOVING
THE LOWER FAIRING).
N
Remove the gearshift lever, see 3.2.2 (REMOVING
THE GEAR LEVER).
N
Remove the clutch control cylinder, see 3.2.3 (REMOV-
ING THE CLUTCH CONTROL CYLINDER).
N
Unscrew and remove the three screws (1).
Screws (1) driving torque: 12 Nm (1.2 kgm).
NOTE
Release the cable of the side stand switch from
the clip.
N
Remove the pinion protection case (2).
N
Remove the guide plate (3).
N
Make sure the guide plate (3) is not worn or damaged;
if so, replace with a new one.

2.36.6 INSPECTING THE DRIVING CHAIN SHOE

N
Position the vehicle on the stand.
N
Make sure the shoe (4) is not worn or damaged; if so,
replace with a new one, see 7.1.54 (REMOVING THE
DRIVING CHAIN SHOE).
N
Check the wear of the chain plastic guide (5).
2 - 60
- 00
RSV mille
Release 00/2002-10