Removing The Air Conveyor - APRILIA RSV mille Workshop Manual

CHASSIS

7.1.33 REMOVING THE AIR CONVEYOR

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the air conveyor cover, see 7.1.31 (REMOV-
ING THE AIR CONVEYOR COVERS).
N
Disconnect the electric connector (2) from the air ther-
mistor (1) (on left side of vehicle only).
a
CAUTION
When reassembling, make sure the electric connec-
tor (2) is plugged in properly and that the cable is re-
fitted in the appropriate seat.
N
Slide the cable of the air thermistor (1) from the seats
(on left side of vehicle only).
N
Unscrew and remove the upper fastening screw (3).
Screw (3) driving torque: 4 Nm (0.4 kgm).
a
CAUTION
Upon reassembly, tighten the screw (3) applying the
prescribed torque, since it is fixed on plastic.
N
Unscrew and remove the lower fastening screw (4).
Screw (4) driving torque: 4 Nm (0.4 kgm).
N
Unscrew and remove the front fastening screw (5).
Screw (5) driving torque: 5 Nm (0.5 kgm).
N
Unscrew and remove the two rear fastening screws (6).
Screws (6) driving torque: 5 Nm (0.5 kgm).
N
Partially remove the air conveyor case (7).
N
Open the collar (8) and release the electric wiring.
a
CAUTION
When reassembling, refit the electric wiring inside
the collar (8).
N
Remove the air conveyor case (7) completely.
N
On left side of vehicle only; where necessary, unscrew
and remove the screw (9) and slide out the grating (10)
complete with air thermistor (1).
NOTE
Where necessary, repeat the procedure to re-
move the other air conveyor case.
7 - 26
- 00
RSV mille
Release 00/2002-10