Assembling The Final Drive Unit Bearings - APRILIA RSV mille Workshop Manual

CHASSIS
7.3.16 ASSEMBLING THE FINAL DRIVE UNIT
BEARINGS
If provided:
N
Remove the final drive unit bearings, see 7.3.15 (DIS-

ASSEMBLING THE FINAL DRIVE UNIT BEARINGS).

Work from the left-hand side:
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8140180 (bearing extractors).
N
Using the appropriate pad, insert the right bearing (6)
completely.
NOTE
The right bearing must be inserted until its con-
tact with the wheel hub shoulder is complete (Y).
N
Insert the inner spacer (5).
N
Use a special pad to insert the left bearing (4).
NOTE
The complete insertion of the left bearing (4) will
bring the following components into contact:
– right bearing (6);
– inner spacer (5);
– left bearing (4).
N
Insert the elastic ring (3).
NOTE
The elastic ring (3) is provided only on the left
side of the final drive unit.
N
Install a new seal (2).
N
Insert the left (1) with the longer diameter towards the
outside of the vehicle.
Work from the right-hand side:
N
Insert the right spacer (7) with the longer diameter to-
wards the outside of the vehicle.
7 - 62
- 00
RSV mille
Release 00/2002-10