APRILIA RSV mille Workshop Manual page 164

RSV mille
ã
Follow
N ✖
Loosen the two clamps (4) (5).
a
CAUTION
✖
Take extreme care when removing the throttle body
(6) as it remains connected to cables and pipes.
N ✖
Grip the throttle body firmly (6), complete with air filter
casing (7), and shift it slightly one way and the other, lift-
ing and sliding it off the intake flanges.
N ✖
Move the throttle body off to the left-hand side of the
vehicle.
N ✖
Unscrew and remove the two screws (8) fastening the
intake flange (9) to the front cylinder and recover the
washers.
N ✖
Remove the intake flange (9) of cylinder "1" (front).
N ✖
Fit the vacuometer intake flange (2) in place, and po-
sition it so that the connector (10) is on the right-hand
side of the vehicle.
N ✖
Fit the two screws (8) back in place with their respec-
tive washers and tighten them.
Torque settings of screws (8): 19 Nm (1.9 kgm).
a
CAUTION
✖
The throttle body (6) must be fitted perfectly on the
intake flanges;
The clamps (4) (5) must be properly tightened.
N ✖
Fit the throttle body (6) again, complete with air filter
casing (7), to the two intake flanges.
N ✖
Tighten the two clamps (4) (5).
N
Slide the pipe (11) off the vacuum connector.
N
Hang the vacuometer (3) on the handlebars.
N
Insert the free end of the vacuometer pipe (12) into the
connector (13).
N ✖
Insert the free end of the vacuometer pipe (14) into
the connector (10) of the intake flange (2).
N
From engine # 686065. Insert the free end of the vac-
uometer pipe (14) into the connector (1) of the throttle
body.
Release 00/2002-10
ã
Follow
FUEL SUPPLY SYSTEM
4 - 27
- 00