APRILIA RSV mille Workshop Manual page 264

RSV mille
7.1.36 REMOVING THE REAR FAIRING REAR END
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Turn the ignition switch to position "1".
N
Remove the passenger seat, see 7.1.2 (UNLOCKING/
LOCKING THE PASSENGER SEAT).
N
Disconnect the rear light electric connector (1).
a
CAUTION
Upon reassembly, make sure that the electric con-
nector (1) is correctly coupled.
N
Unscrew and remove the two upper fastening screws
(2).
Screws (2) driving torque: 5 Nm (0.5 kgm).
N
Unscrew and remove the two lower fastening screws
(3).
Screws (3) driving torque: 3 Nm (0.3 kgm).
a
CAUTION
Handle the plastic and painted components with care
to avoid scraping or damaging them.
N
Remove the end of the rear part of the fairing (4), com-
plete with rear light (5).
7.1.37 REMOVING THE REAR LIGHT
N
Remove the rear fairing rear end (4), see 7.1.36 (RE-
MOVING THE REAR FAIRING REAR END).
N
Unscrew and remove the two screws (6) and retrieve
the two washers.
a
CAUTION
Handle the transparent part with care to avoid scrap-
ing or damaging it.
N
Remove the rear light (5).
Release 00/2002-10
CHASSIS
7 - 29
- 00