Removing The Lower Fairing - APRILIA RSV mille Workshop Manual

RSV mille

7.1.34 REMOVING THE LOWER FAIRING

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the appropriate rear support
stand, see 1.8.2 (POSITIONING THE VEHICLE ON
THE REAR SUPPORT STAND m).
a
CAUTION
Wait until the engine and the exhaust silencer have
completely cooled down.
N
Remove the two side fairings, see 7.1.28 (REMOVING
THE SIDE FAIRINGS).
N
Unscrew and remove the two front fastening screws
(1).
Screws (1) driving torque: 5 Nm (0.5 kgm).
~ Unscrew and remove the rear screw (2).
Screws (2) driving torque: 5 Nm (0.5 kgm).
N
Unscrew and remove the two screws (3) of the rear
right profile (4) (inside the exhaust silencer).
Screws (3) driving torque: 5 Nm (0.5 kgm).
a
CAUTION
Handle the plastic and painted components with care
to avoid scraping or damaging them.
N
Let the side stand down.
N
Withdraw the two pipes (5) (6) from the hole provided
on the fairing.
N
Remove the entire lower fairing (7) by lowering it and
with small movements try to find the best position to
withdraw it from the side stand.
NOTE
Upon reassembly, introduce the two pipes (5)
(6) in the hole provided on the fairing.
N
Take the rear right profile (4).
NOTE
Upon reassembly, the upper part of the profile
(4) must be fitted between the lower fairing (7) and the
support plate.
N
If the inner acoustic insulation edging proves damaged,
replace it.
N
Where necessary, disassemble the lower fairing (7)
into three parts (left, right, front) after removing the stop
rings (8), sliding out the respective pins (9) and retriev-
ing the washers (10).
Release 00/2002-10
CHASSIS
7 - 27
- 00