Removing The Dashboard/Front; Fairing Mount; Removing The Front Mudguard - APRILIA RSV mille Workshop Manual

RSV mille

7.1.26 REMOVING THE DASHBOARD/FRONT

FAIRING MOUNT

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the dashboard's upper protection moulding,
see 7.1.24 (REMOVING THE DASHBOARD'S UPPER
PROTECTION MOULDING).
N
Remove the dashboard, see 7.1.25 (REMOVING THE
DASHBOARD).
N
Remove the steering shock absorber, see 7.7.6 (RE-
MOVING THE STEERING SHOCK ABSORBER).
N
Remove the air conveyor covers, see 7.1.31 (REMOV-
ING THE AIR CONVEYOR COVERS).
N
Slide the blinker (1) from the relevant coupling.
N
Unscrew and remove the two screws (2) and retrieve
the safety clip (3).
N
Move the secondary fuse box (4) over to the side.
N
Unscrew and remove the two screws (5).
Screws (5) driving torque: 3 Nm (0.3 kgm).
N
Move the relay box (6) over to the side.
N
Open the collar (7) and release the clutch fluid pipe and
the cold start cable.
a
CAUTION
When reassembling, refit the pipe and cable inside
the collar (7).
N
Release the wiring from the two special clamps (8).
N
Release the wiring from the clamps (9) and (10).
NOTE
Prepare the same number of clamps, which will
be required for reassembly.
N
Unscrew and remove the two nuts (11).
Nuts (11) driving torque: 12 Nm (1.2 kgm).
N
Unscrew and remove the two screws (12).
N
Remove the dashboard /front fairing mount (13) by lift-
ing it out.

7.1.27 REMOVING THE FRONT MUDGUARD

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
~ Unscrew and remove the two screws (14).
Screws (14) driving torque: 5 Nm (0.5 kgm).
a
CAUTION
Handle the plastic and painted components with care
to avoid scraping or damaging them.
N
Pull the mudguard (15) out from the front.
Release 00/2002-10
CHASSIS
7 - 23
- 00