Final Drive Unit Bearings - APRILIA RSV mille Workshop Manual

RSV mille

7.3.10 FINAL DRIVE UNIT BEARINGS

Carry out the check with the bearings mounted on the fi-
nal drive unit.
CHECKING THE ROTATION
N
Remove the left spacer (1).
N
Remove the right spacer (2).
N
Manually rotate the inner ring of each single bearing.
The rotation must be regular, smooth and noiseless.
If one or both bearings is/are not in compliance with the
check parameters:
N
Change both final drive unit bearings, see 7.3.16 (AS-
SEMBLING THE FINAL DRIVE UNIT BEARINGS).
a
WARNING
Always change both bearings.
Always replace the bearings with bearings of the
same type.
CHECKING THE END AND RADIAL PLAY
N
Check the radial play and the end play.
End play: a minimum end play is allowed.
Radial play: none.
If one or both bearings is/are not in compliance with the
check parameters:
N
Change both final drive unit bearings, see 7.3.16 (AS-
SEMBLING THE FINAL DRIVE UNIT BEARINGS).
a
WARNING
Always change both bearings.
Always replace the bearings with bearings of the
same type.
Release 00/2002-10
CHASSIS
7 - 57
- 00