Fitting The Pins For The Rear Wheel Stand; Placing The Vehicle On The Rear Wheel Stand - APRILIA RSV 1000 R Factory Use And Maintenance Book

6
◆
Hold the air cleaner (6) in a vertical
position and tap it repeatedly on a clean
bench.
◆
If needed, blow the air cleaner (6) with
an air line. Aim the gun from the inside of
the meshing outwards.
CAUTION
When cleaning the air cleaner, ensure
the meshing is not torn. Always change
a damaged air cleaner.
◆
Clean the outer surface of the air cleaner
(6) with a clean cloth.
REPLACEMENT
CAUTION
Never reuse an air cleaner.
◆
Replace the air cleaner (6) with a new air
cleaner of the same type.
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
70
FITTING THE PINS FOR THE REAR
WHEEL STAND
◆
Place the vehicle on the stand, see page
60 (PLACING THE VEHICLE ON THE
STAND).
Fit the pin (7) into the suitable seat in
the swinging arm.
Start the screw (8) into the threaded
hole in the swinging arm and tighten.
PLACING THE VEHICLE ON THE
REAR WHEEL STAND
◆
Fit the two pins (7), see page 70
(FITTING THE PINS FOR THE REAR
WHEEL STAND ).
NOTE
Ask someone to help you keep
the vehicle upright with both wheels on the
ground.
Slacken the knob (9).
Shift the fork-shaped support (10) so
that its width matches the distance
between the two pins fitted to the
swinging arm.
Tighten the knob (9).
◆
Slide both fork-shaped seats (10) of the
stand (11) underneath the pins (7) fitted
to the vehicle at the same time.
◆
Place one foot on the rear end of the
stand (11).
◆
Push down on the stand (11).
CAUTION
Make sure the vehicle is stable.