Removing The Passenger Seat Lock; Removing The Rear Direction; Indicators - APRILIA RSV mille Workshop Manual

RSV mille

7.1.39 REMOVING THE PASSENGER SEAT LOCK

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the rear fairing, see 7.1.38 (REMOVING THE
REAR FAIRING).
N
Unscrew and remove the two fastening screws (1) se-
curing the key-operated control (2).
Screws (1) driving torque: 12 Nm (1.2 kgm).
N
Unscrew and remove the two fastening screws (3) se-
curing the lock (4) and retrieve the two bushes.
Screws (3) driving torque: 10 Nm (1.0 kgm).
N
Remove the lock unit complete with key-operated con-
trol (2) + wire (5) + lock (4).
a
CAUTION
When reassembling, make sure the wire (5) is posi-
tioned correctly and is not twisted.
N
Retrieve the bracket (6) supporting the rear light and
rear fairing.

7.1.40 REMOVING THE REAR DIRECTION

INDICATORS

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the passenger seat, see 7.1.2 (UNLOCKING/
LOCKING THE PASSENGER SEAT).
N
Turn the ignition switch to position "1".
N
Disconnect the electric connector (7).
a
CAUTION
Upon reassembly, make sure that the electric con-
nector (7) is correctly coupled.
N
Loosen and remove the nut (8).
Nut (8) driving torque: 2 Nm (0.2 kgm).
N
Unscrew and remove the screw (9).
N
Loosen and remove the nut (10).
Nut (10) driving torque: 2 Nm (0.2 kgm).
N
Unscrew and remove the screw (11).
N
Remove the direction indicator (12).
a
CAUTION
When removing the direction indicator (12), help the
electric cable, complete with relevant connector,
through the special slots to be found on the saddle
support lower moulded cover and on the number
plate holder.
NOTE
Where necessary, repeat the procedure to re-
move the other direction indicator.
Release 00/2002-10
CHASSIS
7 - 31
- 00