Positioning The Vehicle On The Front Support Stand M - APRILIA RSV mille Workshop Manual

GENERAL INFORMATION
1.8.4 POSITIONING THE VEHICLE ON THE CENTRE
SUPPORT STAND m
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
NOTE Have the appropriate special tool m to hand:
– aprilia part# 8146486 (front support stand).
N
Set the vehicle on the relevant front support stand, see
1.8.3 (POSITIONING THE VEHICLE ON THE FRONT
SUPPORT STAND m).
~Hold the nut on the inside (1) still.
Driving torque of the engine-frame rear fastening
screw: 50 Nm (5.0 kgm).
~Unscrew and remove the engine upper rear fastening
screw (2).
NOTE
The screw (2) on the left-hand side is longer.
~Retrieve the nut (1).
N
Insert the upper right support pin (3) in the upper hole
on the right-hand side.
N
Insert the stud bolt (4) in the upper hole on the left-hand
side and screw it all the way onto the pin (3).
N
Screw the upper left support pin (5) all the way onto the
stud bolt (4) and tighten.
~Hold the nut on the inside (6) still.
Driving torque of the engine-frame lower fastening
screw: 50 Nm (5.0 kgm).
~Unscrew and remove the engine lower rear fastening
screw (7).
NOTE
The screw (7) on the right-hand side is longer.
N
Insert the lower right support pin (8) in the lower hole on
the right-hand side.
N
Insert the stud bolt (9) in the lower hole on the left-hand
side and screw it all the way onto the pin (8).
N
Screw the lower left support pin (10) all the way onto
the stud bolt (9) and tighten.
N
Place the support bracket (11) with the longer side of
the base facing forwards, on the two support pins (3 -
8).
N
Insert the two washers (12) (13) and two nuts (14) (15),
screwing them on by hand.
N
Tighten the two nuts (14) (15).
N
Place the support bracket (16) with the longer side of
the base facing forwards, on the two support pins (5)
(10).
N
Insert the two washers (17) (18) and two nuts (19) (20),
screwing them on by hand.
N
Tighten the two nuts (19) (20).
N
Remove the front and rear support stands.
1 - 22
- 00
RSV mille
Release 00/2002-10