Checking Throttle Valve Control Shaft End Play - APRILIA RSV mille Workshop Manual

RSV mille
4.8.7 CHECKING THROTTLE VALVE CONTROL
SHAFT END PLAY
N
Partially remove the fuel tank, see 7.1.5 (PARTIAL RE-
MOVAL OF THE FUEL TANK).
N
Remove the air filter casing, see 7.1.7 (REMOVING
THE AIR CLEANER CASE).
NOTE
Have an appropriate thickness gauge (1) to
hand with a 0.05 mm scale.
With throttle valves closed:
N
Use the thickness gauge (1) to measure the minimum
play between the lever (2) and the contact surface (3)
on the throttle body in a number of points.
End play: min. 0.1 mm.
a
CAUTION
If the minimum value measured is lower than 0.1 mm,
the throttle body must be replaced, see 0.4.2 (SPARE
PARTS CATALOGUES).
With throttle valves open:
N
Repeat the above procedure.
End play: min. 0.15 mm.
a
CAUTION
If the minimum value measured is lower than 0.15
mm, the throttle body must be replaced, see 0.4.2
(SPARE PARTS CATALOGUES).
Release 00/2002-10
FUEL SUPPLY SYSTEM
4 - 23
- 00