RSV mille
7.3.13 DISASSEMBLING THE REAR WHEEL
BEARINGS
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Remove the rear wheel, see 7.3.1 (REMOVING THE
REAR WHEEL).
N
Use a cloth to clean both sides of the hub.
Work on the right side of the wheel:
N
Remove the right spacer (1).
N
Remove the seal (2).
N
Remove the snap ring (3).
NOTE
The elastic ring (3) is provided only on the right
side of the wheel.
The ends of the spacer (4) are provided with slots (A) to
allow the passage of the extractor teeth.
NOTE
Have the appropriate special tool m to hand:
– aprilia part# 8140180 (bearing extractors).
N
Use a special extractor to extract the right bearing (5).
N
Retrieve the inner spacer (4).
Work from the left-hand side of the wheel:
NOTE
Have the appropriate special tool m to hand:
– aprilia part# 8140180 (bearing extractors).
N
Use a special extractor to extract the left bearing (6).
N
Thoroughly clean the inside of the hub.
NOTE
Wash all the components with a clean deter-
gent.
Release 00/2002-10
CHASSIS
7
- 59
- 00