Removing The Rider's Footrest; Supports - APRILIA RSV mille Workshop Manual

RSV mille
7.1.45 REMOVING THE PASSENGER FOOTREST
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
a
WARNING
Wait until the engine and the exhaust silencer have
completely cooled down.
N
Remove the stop ring (1).
N
Slide out the pin (2).
a
CAUTION
Take care not to loose the ball (5) ejected by the
spring (6) in the process.
N
Remove the footrest (3) and retrieve the two shims (4),
ball (5) and spring (6).
NOTE
Where necessary, repeat the procedure to re-
move the other footrest.

7.1.46 REMOVING THE RIDER'S FOOTREST

SUPPORTS

Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
N
Position the vehicle on the stand.
a
WARNING
Wait until the engine and the exhaust silencer have
completely cooled down.
N
Unscrew and remove the screw (7) supporting the low-
er fairing.
Screw (7) driving torque: 5 Nm (0.5 kgm).
N
Unscrew and remove the two screws (8).
Screws (8) driving torque: 25 Nm (2.5 kgm).
N
Remove the whole rider's footrest support (9).
NOTE
Where necessary, repeat the procedure to re-
move the other rider's footrest support.
To disassemble the components of the rider footrest
support, proceed as follows:
N
Unscrew and remove the two screws (10) and retrieve
the protection element (11).
Screws (10) driving torque: 6 Nm (0.6 kgm).
N
Unscrew and remove the screw (12) and retrieve the
bracket (13).
Screw (12) driving torque: 12 Nm (1.2 kgm).
N
Remove the rider footrest (9), see 7.1.47 (REMOVING
THE RIDER'S FOOTREST).
Release 00/2002-10
CHASSIS
7 - 35
- 00