APRILIA RSV mille Workshop Manual page 268

RSV mille
ã
Follow
N
Open the clamp (14) securing the wiring on the left.
a
CAUTION
When reassembling, make sure the electric compo-
nents and relevant wiring are refitted correctly.
N
Unscrew and remove the two front fastening screws
(15).
Screws (15) driving torque: 4 Nm (0.4 kgm).
~ Loosen and remove the rear fastening nut (16).
Nut (16) driving torque: 4 Nm (0.4 kgm).
~ Pull the screw (17) out from underneath.
~ Unscrew and remove the lower fastening screw (18)
and retrieve the bush (19) for securing luggage.
Screw (18) driving torque: 5 Nm (0.5 kgm).
N
Lower the rear part and lift the front of the saddle sup-
port lower moulded cover (20).
N
Remove the saddle support lower moulded cover (20),
complete with direction indicators and number plate
holder, sliding it off the back.
NOTE
Where necessary, remove the number plate
holder, see 7.1.42 (REMOVING THE NUMBER PLATE
HOLDER) and the direction indicators, see 7.1.40 (RE-
MOVING THE REAR DIRECTION INDICATORS).
Release 00/2002-10
CHASSIS
7 - 33
- 00