APRILIA RSV mille Workshop Manual page 198

RSV mille
6.4.11CHECKING THE INTAKE PRESSURE SENSOR
With the engine switched off:
N
Lift the fuel tank, see 2.8 (LIFTING THE FUEL TANK).
N
Disconnect the three-way connector (1) (coloured
black).
a
CAUTION
Upon reassembly, make sure that the electric con-
nector (1) is correctly coupled.
N
Turn the ignition switch to position "2".
N
By means of a tester, measure the supply voltage be-
tween the external terminals of the connector (1);
measure (A).
Standard value: 4.5 – 5.5 V.
N
Turn the ignition switch to position "1".
N
Using a pocket tester (scale kΩ), measure the resist-
ance between the terminals of the sensor (2).
NOTE
Measurements (B), (C) and (D) must be taken
individually, not at the same time.
Measurements (B), (C) and (D) must produce the follow-
ing values:
Standard values:
– measurement (B) 12 kΩ ± 10%;
– measurement (C) 11.50 kΩ ± 10%;
– measurement (D) 4 kΩ ± 10%.
If the resistance proves to be any value other than
that prescribed, the sensor (2) must be changed.
Release 00/2002-10
ELECTRIC SYSTEM
6 - 17
- 00