Position Sensor; Checking The Fall Sensor - APRILIA RSV mille Workshop Manual

RSV mille
6.4.6 CHECKING THE CAMSHAFT POSITION
SENSOR
With the engine switched off:
N
Lift the fuel tank, see 2.8 (LIFTING THE FUEL TANK).
N
Disconnect the two-way connector (1) (coloured white)
and take the measurements (on the engine-side termi-
nals).
a
CAUTION
Upon reassembly, make sure that the electric con-
nector (6) is correctly coupled.
Using a pocket tester (scale x 100 Ω), measure the re-
N
sistance between the terminals of the blue/yellow (B/G)
and white/yellow (Bi/G) cables.
Standard value: 150 – 350 Ω.
If the resistance is infinite (
scribed level, the sensor must be changed.

6.4.7 CHECKING THE FALL SENSOR

With the engine switched off:
N
Put back the rider saddle, see 7.1.1 (REMOVING THE
RIDER SADDLE).
Check whether the sensor (2) is fitted correctly (with the
arrow inscribed on the rubber element pointing up).
N
Disconnect the two-way connector (3) (coloured white/
grey) and take the measurements (on the sensor-side
terminals).
a
CAUTION
Upon reassembly, make sure that the electric con-
nector (3) is correctly coupled.
N
Using a pocket tester (scale x 100 kΩ), measure the re-
sistance between the terminals of the black and white/
black (N - Bi/N) cables).
Standard value: resistance 62 kΩ ± 15 %.
N
Remove the sensor (2) complete with rubber element
from its housing and tilt it sideways at an angle of over
45° (simulating the condition of a vehicle resting on the
ground).
Standard value: 0 – 1 Ω.
If the resistance is any value other than that pre-
scribed, the sensor (1) must be changed.
N
Repeat the procedure, tilting the sensor in the opposite
direction.
Release 00/2002-10
∞
) or lower than the pre-
ELECTRIC SYSTEM
6 - 13
- 00